OpenGate in the Utilities sector

Why in Utilities?
Because OpenGate is a product designed for M2M solutions of Telemetry and Remote Control. Its connectivity capacity is designed for comunicating with many different types of machines, and to pass these communications over to the applications in the Control Center.

What is the solution based on?
The solution is based on devices of general use, with an interface for communicating with the machine's aplication, and with the ability of communicating via GPRS.

OpenGate provides the mechanisms for the machines to communicate with the application, as if it was a point to point application.

OpenGate in Telemetry
OpenGate has an embedded software for the data capture of digital, analogic and CAN bus data. The released software will periodically insert into a database any read data, without the need of further developing.

OpenGate in Remote Control
OpenGate provides a two-way communication channel between machines and applicarion, so that at any moment a command can be sent from the application to the machine. These orders will be translated into pulses in the event of digital outputs, or the one that corresponds in each case.

Where can it be used?

Automatons (Irrigation, floodgates...)

Water meters, gas meters...

Electricity generator, windmills...

wells, dams, water reservoirs...

Factories, energy plants...

and in general, in any place where communication is needed between a sensor and a machine and the control center.